1-43
[aaa_0.H3C:000f-e202-2180]
|
├-(P_0/40)<-->(P_0/6)[Sysname:000f-e200-2200]
|
├-(P_0/28)<-->(P_3/0/1)[Sysname:000f-e200-1774]
|
├-(P_0/24)****(P_1/0/6)[clie:000f-e200-5502]
|
├-(P_0/22)<-->(P_1/0/2)[aaa_5.H3C:000f-e200-5111]
|
├-(P_0/18)<-->(P_3/0/2)[Sysname S7503S3600:000f-e218-d0d0]
|
├-(P_0/14)<-->(P_1/0/2)[Sysname:000f-e200-5601]
|
├-(P_0/10)<-->(P_1/0/1)[aaa_7.S5500-28C-SI:0012-a990-2241]
|
├-(P_0/4)<-->(P_0/2)[2024CS3600:000f-e200-00cc]
|
â””-(P_0/1)****(P_0/1)[Sysname:00e0-fd34-bc66]
display ntdp single-device mac-address
Syntax
display ntdp single-device mac-address mac-address
View
Any view
Parameters
mac-address: MAC address of the device whose detailed information is to be displayed.
Description
Use the display ntdp single-device mac-address command to display the detailed information, which
is collected through NTDP protocol packets, about a single device. The information displayed by the
command is similar to that displayed by the display cluster members command. However, if you want
to display information about a device that is enabled with only NTDP and is not in any cluster, you have
to use the display ntdp single-device mac-address command.
Examples
# Display the detailed information about the switch with the MAC address 000f-e200-3956.
<Sysname> display ntdp single-device mac-address 000f-e200-3956
Hostname : H3C
MAC : 000f-e200-3956
Hop : 0
Platform : H3C S3600-28P-EI
IP :
Version:
To Next Page
Loading...
Need help?
General