KLA Tencor P-16+ - Chapter 8 APEX 2 D;3 D - Getting Started; Introduction; Licence Agreement; Overview of Apex 2 D;3 D

0142530-000 AB KLA-Tencor Confidential 8-1
3/13/09
KLA-Tencor P-16+ / P-6 User’s Guide APEX 2D/3D - Getting Started - Introduction
ary
APEX 2D/3D - GETTING STARTED Chapter 8
8
INTRODUCTION 8
This appendix provides information about configuring Apex 2D/3D to work with the
Profiler system.
LICENCE AGREEMENT 8
 The copyright laws and international treaties, as well as other intellectual
property laws and treaties protect the software product
 The software product is licensed as a single product. Its component parts
may not be separated for use on more than one computer.
 You may not reverse engineer, decompile, or disassemble the software
product.
 The source code was designed and developed by Digital Surf and is the
property of Digital Surf, France.
 Apex 2D and Apex 3D are Trademarks of KLA-Tencor Corp.
OVERVIEW OF APEX 2D/3D 8
Starting the Software 8
The program displays an empty document (below).
To start the software, click the shortcut on the desktop, or
click Program Files >Digital Surf >Apex in the Start
Menu.
Figure 8.1 Empty Document