TP-Link T2600G Series - Page 236

Configuring Protocol VLAN Protocol VLAN Configuration
User Guide
207
Step 5 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet
port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list |
port-channel
port-channel-id | range port-channel port-channel-list }
Enter interface configuration mode.
Step 6 protocol-vlan group
entry-id
Add the specified port to the protocol group.
entry-id: Protocol VLAN index.
Step 7 end
Return to Privileged EXEC Mode.
Step 8 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to bind the IPv6 protocol template to VLAN 10 and add
port 1/0/2 to protocol VLAN:
Switch#configure
Switch(config)#show protocol-vlan template
Index Protocol Name Protocol Type
-------- ------------------ --------------------------------
1 IP EthernetII ether-type 0800
2 ARP EthernetII ether-type 0806
3 RARP EthernetII ether-type 8035
4 IPX SNAP ether-type 8137
5 AT SNAP ether-type 809B
6 IPv6 EthernetII ether-type 86DD
Switch(config)#protocol-vlan vlan 10 priority 5 template 6
Switch(config)#show protocol-vlan vlan
Index Protocol-Name VID Priority Member
-------- -------------------- ------ ------ ------
1 IPv6 10 0
Switch(config)#interface gigabitEthernet 1/0/2
Switch(config-if)#protocol-vlan group 1
Switch(config-if)#show protocol-vlan vlan