TP-Link T2600G Series - Page 248

Configuring Protocol VLAN Configuration Example
User Guide
219
5) Add port 1/0/1 to the protocol groups.
Switch_2(config)#show protocol-vlan vlan
Index Protocol-Name VID Member
---- --------------- ---------- -------------
1 IP 10
2 IPv6 20
Switch_2(config)#interface gigabitEthernet 1/0/1
Switch_2(config-if)#protocol-vlan group 1
Switch_2(config-if)#protocol-vlan group 2
Switch_2(config-if)#exit
Switch_2(config)#end
Switch_2#copy running-config startup-config
Verify the Configurations
■ Switch 1
Verify 802.1Q VLAN configuration:
Switch_1#show vlan
VLAN Name Status Ports
-------- ------------- --------- --------------------------------------------
1 System-VLAN active Gi1/0/1, Gi1/0/2, Gi1/0/3, Gi1/0/4
...
Gi1/0/25, Gi1/0/26, Gi1/0/27, Gi1/0/28
10 IPv4 active Gi1/0/1, Gi1/0/3
20 IPv6 active Gi1/0/2, Gi1/0/3
■ Switch 2
Verify 802.1Q VLAN configuration:
Switch_2#show vlan