TP-Link T2600G Series - Page 271

User Guide 242
Configuring VLAN-VPN Configuration Examples
Switch_3#configure
Switch_3(config)#vlan 100
Switch_3(config-vlan)#name C_VLAN100
Switch_3(config-vlan)#exit
Switch_3(config)#vlan 200
Switch_3(config-vlan)#name C_VLAN200
Switch_3(config-vlan)#exit
2) Add port 1/0/1 to VLAN 100 and port 1/0/2 to VLAN 200 as untagged ports; add port
1/0/3 to VLAN 100 and VLAN 200 as tagged ports. Configure the PVID as 100 for port
1/0/1 and 200 for port 1/0/2.
Switch_3(config)#interface gigabitEthernet 1/0/1
Switch_3(config-if)#switchport general allowed vlan 100 untagged
Switch_3(config-if)#switchport pvid 100
Switch_3(config-if)#exit
Switch_3(config)#interface gigabitEthernet 1/0/2
Switch_3(config-if)#switchport general allowed vlan 200 untagged
Switch_3(config-if)#switchport pvid 200
Switch_3(config-if)#exit
Switch_3(config)#interface gigabitEthernet 1/0/3
Switch_3(config-if)#switchport general allowed vlan 100,200 tagged
Switch_3(config-if)#end
Switch_3#copy running-config startup-config
Verify the VLAN VPN Configurations on Switch 1
Verify the configurations of global VLAN VPN:
Switch_3#show dot1q-tunnel
VLAN VPN Mode: Enabled
Mapping Mode: Disabled
Verify the configurations of VPN up-link port and VPN port:
Switch_3#show dot1q-tunnel interface