TP-Link T2600G Series User Manual

User Guide 390
Configuring Spanning Tree Spanning Tree
» TC Protect
TC Protect function is used to prevent the switch from frequently removing MAC address
entries. It is recommended to enable this function on the ports of non-root switches.
A switch removes MAC address entries upon receiving TC-BPDUs (the packets used to
announce changes in the network topology). If a user maliciously sends a large number of
TC-BPDUs to a switch in a short period, the switch will be busy with removing MAC address
entries, which may decrease the performance and stability of the network.
With TC protect function enabled, if the number of the received TC-BPDUs exceeds the
maximum number you set in the TC threshold, the switch will not remove MAC address
entries in the TC protect cycle.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing