TP-Link T2600G Series User Manual

User Guide 456
Configuring LLDP LLDP-MED Configurations
Figure 3-3 LLDP-MED Port Config-Detail
Network Policy Used to advertise VLAN configuration and the associated Layer 2 and Layer 3
attributes of the port to the endpoint devices.
Location
Identification
Used to assign the location identifier information to the Endpoint devices.
If this option is selected, you can configure the emergency number and the
detailed address of the endpoint device in the Location Identification Parameters
section.
Extended
Power-Via-MDI
Used to advertise the detailed PoE information including power supply priority and
supply status between LLDP-MED Endpoint devices and Network Connectivity
devices.
Inventory Used to advertise the inventory information. The Inventory TLV set contains
seven basic Inventory management TLVs, that is, Hardware Revision TLV,
Firmware Revision TLV, Software Revision TLV, Serial Number TLV, Manufacturer
Name TLV, Model Name TLV and Asset ID TLV.
Emergency
Number
Configure the emergency number to call CAMA or PSAP. The number should
contain 10-25 characters.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing