TP-Link T2600G Series User Manual

Configuring DHCP Service DHCP Server Configuration
User Guide
549
Step 6 dns-server dns-server-list
(Optional) Specify the DNS server of the DHCP server pool. In general, you can configure
the IP address of the VLAN interface as the DNS server address.
dns-server-list : Specify the IP address of the DNS server. You can specify up to 8 DNS
servers for each DHCP server pool.
Step 7 netbios-name-server
NBNS-list
(Optional) Specify the NetBIOS name server. You can specify up to 8 NetBIOS servers for
each DHCP server pool.
When a DHCP client uses the Network NetBIOS (Basic Input Output System) protocol for
communication, the host name must be mapped to IP address. NetBIOS name server can
resolve host names to IP addresses.
NBNS-list : Specify the IP address of the NetBIOS server. You can specify up to 8 NetBIOS
servers for each DHCP server pool.
Step 8 netbios-node-type
type
(Optional) Specify the NetBIOS type for the clients, which is the way of inquiring IP address
resolution.
type : Specify the NetBIOS type. The following options are provided:
b-node: The client sends query messages via broadcast.
p-node: The client sends query messages via unicast.
m-node: The client sends query messages via broadcast first. If it fails, the client will try
again via unicast.
h-node: The client sends query messages via unicast first. If it fails, the client will try again
via broadcast.
Step 9 next-server
ip-address
(Optional) Specify the IP address of a TFTP server for the clients. If needed, the clients can
get the configuration file from the TFTP server for auto installation.
ip-address : Specify the IP address of the TFTP server.
Step 10 domain-name
domainname
(Optional) Specify the domain name that the clients should use when resolving host names
via DNS.
domainname : Specify the domain name with up to 200 characters.
Step 11 bootfile
file-name
(Optional) Specify the name of the bootfile. If needed, the clients can get the bootfile from
the TFTP server for auto installation.
file-name : Specify the bootfile name with up to 128 characters.
Step 12 show ip dhcp server pool
Verify the configuration of the DHCP server pool.
Step 13 end
Return to Privileged EXEC Mode.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing