TP-Link T2600G Series User Manual

User Guide 592
Configuring DHCP Service Configuration Examples
3) Choose the menu L3 FEATURES > DHCP Service > DHCP Relay > DHCP Interface
Relay and click
to load the following page. Specify the DHCP server address
to assign IP addresses for clients in VLAN 2. Click Create.
Figure 5-31 Specify DHCP Server for Interface VLAN 2
4) Click to save the settings.
Using the CLI
Follow these steps to configure DHCP relay and enable Option82 in DHCP Relay on
SwitchA:
1) Enable DHCP Relay.
Switch#configure
Switch(config)#service dhcp relay
2) Enable Option82 for port 1/0/1 and port 1/0/2. Set Option82 policy as Replace. You
can configure other parameters according to your needs. In this example, the Format is
set as Normal, and Circuit ID Customization and Remote ID Customization as Disabled.
Switch#(config)#interface range gigabitEthernet 1/0/1-2
Switch(config-if)#ip dhcp relay information option
Switch(config-if)#ip dhcp relay information strategy replace
Switch(config-if)#ip dhcp relay information format normal
Switch(config-if)#exit
3) Specify the DHCP server for the interface VLAN 2.
Switch(config)#interface vlan 2
Switch(config-if)#ip helper-address 192.168.0.59
Switch(config-if)#end
Switch#copy running-config startup-config
4) Verify the Configurations
View global settings:
Switch#show ip dhcp relay

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing