TP-Link T2600G Series - Page 646

Configuring ARP ARP Configurations
User Guide
617
Step 2
There are three types of Layer 3 interface can be enabled with Local Proxy ARP: routed port,
port-channel and VLAN interface.
interface { fastEthernet
port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet
port-list | ten-gigabitEthernet port | ten-range gigabitEthernet port-list |
port-channel
port-channel | range port-channel port-channel-list |}
no switch port
Enter interface configuration mode and change the port or port-channel to be a Layer 3
interface.
Interface vlan
vlan - id
Enter the vlan interface configuration mode.
vlan - id: Enter the interface VLAN ID.
Step 3 ip local-proxy-arp
Enable Local Proxy ARP function on the specified Layer 3 interface..
Step 4 show ip local-proxy-arp
Show the Local Proxy ARP configuration..
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
This example shows how to enable Local Proxy ARP function for VLAN interface 1:
Switch#configure
Switch(config)#interface vlan 1
Switch(config-if)#ip local-proxy-arp
Switch(config-if)#show ip local-proxy-arp
Interface IP Address IP Mask Status
----------- --------------- --------------- --------
vlan 1 192.168.0.1 255.255.255.0 Enabled
Switch(config-if)#end
Switch#copy running-config startup-config