TP-Link T2600G Series User Manual

User Guide 700
Configuring Access Security Access Security Configurations
HTTP HTTP function is based on the HTTP protocol. It allows users to manage the
switch through a web browser.
Port Specify the port number for HTTP service.
2) In the Session Config section, specify the Session Timeout and click Apply.
Session
Timeout
The system will log out automatically if users do nothing within the Session
Timeout time.
3) In the Number of Access Users section, enable Number Control function, specify the
following parameters and click Apply.
Number Control Enable or disable Number Control. With this option enabled, you can control the
number of the users logging on to the web management page at the same time.
The total number of users should be no more than 16.
Number of
Admins
Specify the maximum number of users whose access level is Admin.
Number of
Operators
Specify the maximum number of users whose access level is Operator.
Number of
Power Users
Specify the maximum number of users whose access level is Power User.
Number of
Users
Specify the maximum number of users whose access level is User.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing