User Guide 798
Configuring ACL ACL Configuration
Burst Size Specify the number of bytes allowed in one second.
Out of Band Select the action for the packets whose rate is beyond the specified rate.
None: The packets will be forwarded normally.
Drop: The packets will be discarded.
Remark DSCP: You can specify a DSCP value, and the DSCP field of the
packets will be changed to the specified one.
Note: Remark DSCP is not available for T2600G-18TS.
5) In the Policy section, enable or disable the QoS Remark feature for the matched
packets. With this option enabled, configure the related parameters, and the remarked
values will take effect in the QoS processing on the switch.
Figure 2-26 Configuring QoS Remark
DSCP Specify the DSCP field for the matched packets. The DSCP field of the
packets will be changed to the specified one.
Local Priority Specify the local priority for the matched packets. The local priority of the
packets will be changed to the specified one.
802.1p Priority Specify the 802.1p priority for the matched packets. The 802.1p priority of
the packets will be changed to the specified one.
6) Click Apply.
To Next Page
Loading...
