3-20
The switch timer can be set to a precision of one minute, that is, the switch will reboot within one minute
after the specified reboot date and time.
After you execute the command, the system will prompt you to confirm. Enter "Y" or "y" for your setting
to take effect. Your setting will overwrite the previous one (if available).
If you adjust the system time by the clock command after executing the schedule reboot regularity
command, the configured schedule reboot regularity command will be invalid.
Related commands: reboot, schedule reboot at, undo schedule reboot, display schedule reboot.
Examples
# Schedule a reboot so that the switch reboots at 10:00 every Thursday.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] schedule reboot regularity at 10:00 thursday
Schedule reboot regularity, are you sure?[Y/N]:y
[Sysname]
system-monitor enable
Syntax
system-monitor enable
undo system-monitor enable
View
System view
Parameters
None
Description
Use the system-monitor enable command to enable real-time monitoring of the running status of the
system.
Use the undo system-monitor enable command to disable real-time monitoring of the running status
of the system.
This function enables you to dynamically record the system running status, such as CPU, thus
facilitating analysis and solution of the problems of the device.
By default, real-time monitoring of the running status of the system is enabled.
To Next Page
Loading...
Need help?
General