H3C S3600 Series Command Manual

1-1
1 Port Isolation Configuration Commands
Port Isolation Configuration Commands
display isolate port
Syntax
display isolate port
View
Any view
Parameters
None
Description
Use the display isolate port command to display the Ethernet ports assigned to the isolation group.
Examples
# Display the Ethernet ports added to the isolation group.
<Sysname> display isolate port
Isolated port(s) on UNIT 1:
Ethernet1/0/2, Ethernet1/0/3, Ethernet1/0/4
The information above shows that Ethernet1/0/2, Ethernet1/0/3, and Ethernet1/04 are in the isolation
group. Neither Layer-2 nor Layer-3 packets can be exchanged between these ports.
port isolate
Syntax
port isolate
undo port isolate
View
Ethernet port view
Parameters
None
Description
Use the port isolate command to assign the Ethernet port to the isolation group.
Use the undo port isolate command to remove the Ethernet port from the isolation group.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English