TP-Link T2600G Series - Page 1020

Configuring OAM Ethernet OAM Configurations
User Guide
991
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable Error Frame Period notification and configure
the threshold as 1 and the window as 1488100 on port 1/0/1:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#ethernet-oam link-monitor frame-period threshold 1 window
1488100 notify enable
Switch(config-if)#show ethernet-oam configuration interface gigabitEthernet 1/0/1
Gi1/0/1
-----------------------------------------------------------
...
Frame Period Error
Notify State : Enabled
Window : 1488100 Frames
Threshold : 1 Error Frame
...
Switch(config-if)#end
Switch#copy running-config startup-config
■ Configuring Error Frame Seconds Event
An Error Frame Seconds event occurs if the number of error frame seconds exceeds the
threshold within a specific period of time. A second is called an error frame second if error
frames occur in the second.
Follow these steps to configure Error Frame Seconds event:
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet
port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet
port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.