Notification Configurations
User Guide
1049
■ Enabling the DDM Traps Globally
Note:
T2600G-52TS does not support DDM traps.
Step 1 configure
Enter Global Configuration Mode.
Step 2 snmp-server traps ddm [ temperature | voltage | bias_current | tx_power | rx_power ]
Enable the corresponding DDM traps. DDM function is used to monitor the status of the
SFP modules inserted into the SFP ports on the switch. The command without parameter
enables all SNMP DDM traps. By default, all DDM traps are disabled.
temperature: Monitors the temperature of SFP modules inserted into the SFP ports on the
switch. The trap can be triggered when the temperature of any SFP module has reached the
warning or alarm threshold.
voltage: Monitors the voltage of SFP modules inserted into the SFP ports on the switch. The
trap can be triggered when the voltage of any SFP module has reached the warning or alarm
threshold.
bias_current: Monitors the bias current of SFP modules inserted into the SFP ports on the
switch. The trap can be triggered when the bias current of any SFP module has reached the
warning or alarm threshold.
tx_power: Monitors the TX Power of SFP modules inserted into the SFP ports on the switch.
The trap can be triggered when the TX Power of any SFP module has reached the warning
or alarm threshold.
rx_power: Monitors the RX Power of SFP modules inserted into the SFP ports on the switch.
The trap can be triggered when the RX Power of any SFP module has reached the warning
or alarm threshold.
Step 3 end
Return to Privileged EXEC Mode.
Step 4 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure the switch to enable DDM temperature trap:
Switch#configure
Switch(config)#snmp-server traps ddm temperature
Switch(config)#end
Switch#copy running-config startup-config
■ Enabling the VLAN Traps Globally
Step 1 configure
Enter Global Configuration Mode.
To Next Page
Loading...
Need help?
General
