TP-Link T2600G Series User Manual

Notification Configurations
User Guide
1053
Switch#copy running-config startup-config
■ Enabling the Link-status Trap for Ports
Step 1 configure
Enter Global Configuration Mode.
Step 2 interface {fastEthernet
port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet
port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Configure notification traps on the specified ports.
port/port-list: The number or the list of the Ethernet ports that you desire to configure
notification traps. To configure multiple ports, enter a list of port numbers separated
by commas, or use a hyphen to indicates a range of port numbers. For example, 1-3, 5
indicates port 1, 2, 3, 5.
Step 3 snmp-server traps link-status
Enable Link Status Trap for the port. By default, it is enabled. Link Status Trap (including
Linkup Trap and Linkdown Trap) can be triggered when the link status of a port changes,
and the trap is enabled both globally and on the port.
To enable Linkup Trap and Linkdown Trap globally, run the command snmp-server traps
snmp [ linkup | linkdown ] in Global Configuration Mode. To disable it, run the corresponding
no command.
Step 4 end
Return to Privileged EXEC Mode.
Step 5 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure the switch to enable link-status trap:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#snmp-server traps link-status
Switch(config-if)#end
Switch#copy running-config startup-config

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing