User Guide 1070
Configuration Example
Figure 6-5 Creating an SNMP User
5) Choose MAINTENANCE > SNMP > Notification > Notification Config and click
to load the following page. Choose the IP Mode as IPv4, and specify the IP address of
the NMS host and the port of the host for transmitting notifications. Specify the User as
admin and choose the type as Inform. Set the retry times as 3, with the timeout period
as 100 seconds. Click Create.
Figure 6-6 Creating an SNMP Notification Entry
6) Choose MAINTENANCE > SNMP > Notification > Trap Config to load the following
page. Enable Storm Control trap and click Apply.
To Next Page
Loading...
