User Guide 500
Configuring PPPoE ID Insertion PPPoE ID Insertion Configuration
Switch(config-if)#show pppoe id-insertion interface gigabitEthernet 1/0/1
Port Circuit-ID C-ID Type C-ID Value(UDF) Remote-ID R-ID Value
------- ----------- ----------- ---------------------- ----------- ---------------
Gi1/0/1 Enabled UDF-ONLY 123 Enabled host1
Switch(config-if)#end
Switch#copy running-config startup-config
Note:
The member port of an LAG (Link Aggregation Group) follows the configuration of the LAG and not its
own. The configurations of the port can take effect only after it leaves the LAG.
To Next Page
Loading...
