TP-Link T2600G Series User Manual

User Guide 702
Configuring Access Security Access Security Configurations
HTTPS Enable or disable the HTTPS function.
HTTPS function is based on the SSL or TLS protocol. It provides a secure
connection between the client and the switch.
Protocol
Version
Select the protocol version for HTTPS. Make sure the protocol in use is
compatible with that on your HTTPS client.
SSL is a transport protocol. It can provide server authentication, encryption and
message integrity to allow secure HTTP connection.
TLS is a transport protocol upgraded from SSL. It can support a more secure
connection than SSL. TLS and SSL are not compatible with each other.
SSL Version 3.0: Select SSL Version 3.0 as the protocol for HTTPS.
TLS Version 1.0: Select TLS Version 1.0 as the protocol for HTTPS.
TLS Version 1.1: Select TLS Version 1.1 as the protocol for HTTPS.
TLS Version 1.2: Select TLS Version 1.2 as the protocol for HTTPS.
All: Enable all the above protocols for HTTPS. The HTTPS server and client will
negotiate the protocol each time.
Port Specify the port number for HTTPS service.
2) In the CipherSuite Config section, select the algorithm to be enabled and click Apply.
RSA_WITH_
RC4_128_MD5
128-bit RC4 encryption with MD5 message authentication and RSA key exchange.
RSA_WITH_
RC4_128_SHA
128-bit RC4 encryption with SHA-1 message authentication and RSA key
exchange.
RSA_WITH_
DES_CBC_SHA
56-bit DES encryption with SHA-1 message authentication and RSA key
exchange.
RSA_WITH_
3DES_EDE_
CBC_SHA
168-bit Triple DES encryption with SHA-1 message authentication and RSA key
exchange.
ECDHE_WITH_
AES_128_GCM_
SHA256
128-bit AES in Galois Counter Mode encryption with SHA-256 message
authentication and elliptic curve Diffie-Hellman key exchange signed with an RSA
certificate or ECDSA certificate.
ECDHE_WITH_
AES_256_GCM_
SHA384
256-bit AES in Galois Counter Mode encryption with SHA-384 message
authentication and elliptic curve Diffie-Hellman key exchange signed with an RSA
certificate or ECDSA certificate.
3) In the Session Config section, specify the Session Timeout and click Apply.
Session
Timeout
The system will log out automatically if users do nothing within the Session
Timeout time.

TP-Link T2600G Series Specifications

General

Model	T2600G Series
Layer	Layer 2+
Type	Managed
Uplink Ports	4 x Gigabit SFP slots
VLAN	4K VLANs
QoS	8 priority queues
Management	Web-based GUI, CLI, SNMP, RMON
Standards and Protocols	IEEE 802.3i, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z, IEEE 802.3ad, IEEE 802.3x, IEEE 802.1d, IEEE 802.1s, IEEE 802.1w, IEEE 802.1q, IEEE 802.1p, IEEE 802.3af, IEEE 802.3at
Interface	RJ45
L2 Features	STP, RSTP, MSTP, LACP, IGMP Snooping
L3 Features	Static Routing
Security	802.1X, Port Security, DHCP Snooping, IP Source Guard, DoS Defend, ARP Inspection, SSH, SSL, ACL
MAC Address Table	16K
Jumbo Frame	9KB
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% RH non-condensing
Storage Humidity	5% to 90% non-condensing