NEC Univerge SV9100 - Connector Pin-Out on the GPZ-BS10;GPZ-BS11; Figure 3-6 GPZ-BS10 Components; Install the GPZ-BS10 Expansion Base Blade in the CHS2 UG-US Controlling Chassis; Table 3-3 GPZ-BS10;GPZ-BS11 Connector Pin-Out

Issue 3.0
3-10 Installing the SV9100 Chassis
3.3.2.1 Connector Pin-Out on the GPZ-BS10/GPZ-BS11
3.3.2.2 Install the GPZ-BS10 Expansion Base Blade in the
CHS2UG-US Controlling Chassis
1. Ensure the chassis is powered down.
2. Locate the door positioned on the left end (expansion bay)
of the Controlling Chassis (refer to Figure 3-7 GPZ-BS10
Expansion Bay in Controlling Chassis on page 3-11).
Table 3-3 GPZ-BS10/GPZ-BS11 Connector Pin-Out
RJ-61 Cable Connector
GPZ-BS10 –
CN2, CN3, CN 4
GPZ-BS11 – CN3
Pin No. Connection
1HW_UP (+)
2HW_UP (-)
3HW_DWN (+)
4FS (+)
5FS (-)
6HW_DWN (-)
7CK8M (+)
8CK8M (-)
Figure 3-6 GPZ-BS10 Components
WARNING
Do not remove or install this blade with the
power on.