NEC Univerge SV9100 - Figure 5-127 Installing the UTR-1-1 USB Handset Cable; Figure 5-128 Installing the UTR-1-1 USB Handset to a PC

Issue 3.0
5-106 Installing DT Series Digital and IP Multiline Terminals
6.3 UTR-1-1 USB Handset
The NEC USB telephone can be plugged directly into a PC USB port, enabling
the high quality voice input and output abilities of a standard desktop telephone.
By connecting it to the USB port of a computer, calls can immediately be made
and received using a SoftPhone without installation of additional software drivers.
The physical design eliminates stress associated with holding the handset
between the ear and shoulder. The user immediately hears a dial tone after taking
the handset off-hook, eliminating the need to click on/off hook icons in a PC
application when making a call.
6.3.1 Handset Connection
Plug the handset cable (RJ-11 connector) into the bottom of the cradle.
Route the handset cable in the handset groove.
6.3.2 USB Connection
Plug a USB cable (type A connector) into the back of the cradle. Plug the
USB cable (type B connector) in the USB port of a PC.
Figure 5-127 Installing the UTR-1-1 USB Handset Cable
Figure 5-128 Installing the UTR-1-1 USB Handset to a PC