NEC Univerge SV9100 - Table 4-24 GCD-4 COTB LED Indications; Table 4-25 GCD-4 COTB RJ-61 Cable Connector Pin-Outs

Issue 3.0
4-60 Installing the SV9100 Blades
5.1.3 LED Indications
LED indications for the GCD-4COTB are listed in Table 4-24 GCD-4COTB
LED Indications. Each LED is listed with its associated function and LED
and Operational status.
Refer to Figure 4-21 GCD-4COTB Blade on page 4-58 for the location of
the LEDs on the blades.
5.1.4 Connectors
Table 4-25 GCD-4COTB RJ-61 Cable Connector Pin-Outs on page 4-61
shows the pin-outs for the RJ-61 connector. Refer to Figure 4-21
GCD-4COTB Blade on page 4-58 for an illustration showing the location of
the connectors on the GCD-4COTB blades.
Table 4-24 GCD-4COTB LED Indications
LED Indication
Operation Status Remarks
Live LED
(Green)
Busy LED (Red)
On
On System Initializing
–
Flash (1s) On The assignment of the unit is refused.
When you exceed the system
capacity.
When the main software version is
not matched.
Flash (1s) Trouble found during self-diagnostics.
–
Flash
(100ms)
On
Normal
Operation
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle. –
Off
On
Unit Busy
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle. –
Flash 80ms (On/
Off) x 3/400ms
Off
Downloading firmware.
–