NEC Univerge SV9100 - Figure 4-4 Inserting Blades in the 19 Chassis; Figure 4-5 Inserting Blades in the 9.5 Chassis

Issue 3.0
SV9100 System Hardware Manual 4-5
2.2 Installing an Extension or Trunk Blade
2.2.1 Installing the Blades
To install an extension/trunk blade with the system running:
1. Insert the blade in the guide rail and push it securely into position.
Tighten the thumb screw on either side of the blade.
2. The Status LED starts flashing when the blade starts processing (15
seconds).
Figure 4-4 Inserting Blades in the 19” Chassis
Figure 4-5 Inserting Blades in the 9.5” Chassis