NEC Univerge SV9100 - Figure 5-70 Ribbon Cable Installed; Figure 5-71 8 LKI (LD)-L UNIT Installed

Issue 3.0
5-70 Installing DT Series Digital and IP Multiline Terminals
7. Plug ribbon cable on back of 8LKI (LD)-L UNIT into
connector (metal side down) until pressure is felt.
8. Press down on the black bar to lock the cable into place
(refer to Figure 5-70 Ribbon Cable Installed).
9. Align the projections on the bottom of the 8LKI (LD)-L UNIT
with the guide holes on top of the multiline terminal (refer to
Figure 5-70 Ribbon Cable Installed on page 5-70).
10. Slide the 8LKI (LD)-L UNIT toward the keypad buttons until
snug (refer to Figure 5-71 8LKI (LD)-L UNIT Installed).
Figure 5-70 Ribbon Cable Installed
Projection
(One Each Side)
Guide
Guide
Figure 5-71 8LKI (LD)-L UNIT Installed