Issue 3.0
9-22 Installing SV9100 Optional Equipment
2. If a line cord was not previously connected to the PGD(2)-U10 ADP,
complete Steps 3~6. Otherwise, skip to Step 7.
3. Install a modular jack for each PGD(2)-U10 ADP. For each module, run
one-pair 24 AWG station cable from the cross-connect block to a modular
jack. Ground the unused pair.
4. Terminate the extension leads to GRN/RED of the modular jack. Terminate
the unused leads to the jack.
5. Install bridging clips as required.
6. Plug a modular line cord from the mod jack to the CN1 connector on the
PGD(2)-U10 ADP.
7. Connect an RCA jack to the audio output(s) on the back of the
PGD(2)-U10 ADP.
8. The opposite end of this cable is connected to the external music source
either directly or by connecting to the cross-connect block where the music
source is connected.
Figure 9-16 CPRU Connections
To Next Page
Loading...
