Issue 3.0
5-92 Installing DT Series Digital and IP Multiline Terminals
13. Set the height of the tilt leg on the DCL-60-1/DCZ-60-2
CONSOLE to match the tilt leg on the multiline terminal.
14. Attach the side panel to the side of the DCL-60-1/DCZ-60-2
CONSOLE.
15. Return the multiline terminal and DCL-60-1/DCZ-60-2
CONSOLE to the buttons side up position.
16. Connect the digital cable to the LINE jack (DT300/DT400
only).
17. Connect the AC Adapter cable. See Figure 5-101 Connect
AC Adapter Cable on page 5-92.
18. Complete the installation by reattaching both plastic panels
to the front of the multiline terminal.
Figure 5-101 Connect AC Adapter Cable
Figure 5-102 DCL-60-1/DCZ-60-2 CONSOLE Installed
To Next Page
Loading...
