Issue 3.0
5-86 Installing DT Series Digital and IP Multiline Terminals
5.2.8 Installing the Sticker-Braille-L KIT
Stickers 1 and 2 (2-button, 6-button, 12-button and 24-button telephones)
Stickers 1 and 2 are attached by peeling the sticker from the sheet and
applying it to the face plate (it can be applied over the LCD) or by cutting the
sticker from the sheet and placing the sticker in the Directory Card holder.
Sticker 3 (12-button and 24-button telephones)
The LN/LND sticker is applied directly to the button by peeling the sticker
from the sheet and applying it directly on the button face.
Sticker 4 (2-button, 6-button, 12-button, and 24-button telephones)
The HLD/HOLD, SP/SPK and CNF/CONF stickers are applied by peeling
the sticker from the sheet and applying the sticker below the appropriate
button.
Figure 5-93 Sticker-Braille-L KIT (Sheet 1)
To Next Page
Loading...
