NEC Univerge SV9100 - Figure 4-34 Install the SO-DIMM Memory; Figure 4-35 Install the Compact Flash Drive

Issue 3.0
SV9100 System Hardware Manual 4-89
5. Install the Compact Flash drive into slot CN7, make sure the drive is
fully seated in the slot (refer to Figure 4-35 Install the Compact Flash
Drive).
6.1.3 LED Indications
6.1.3.1 Active LED – Green
The Active LED is controlled by the DSP and indicates the
board operational status.
 Off: Power off.
 On: Reset.
 Slow Flash: Board is running but not in sync with the chassis
yet.
 Fast Flash: Board is in sync with the chassis and operating
normally.
Figure 4-34 Install the SO-DIMM Memory
Figure 4-35 Install the Compact Flash Drive