NEC Univerge SV9100 - Figure 9-2 Remove Cover from PGD(2)-U10 ADP; Figure 9-3 Remove Plastic Cover from Cable Hole

Issue 3.0
SV9100 System Hardware Manual 9-3
1. Remove the screw from the front of the PGD(2)-U10 ADP.
2. Using a screwdriver, break out the plastic piece covering the cable hole.
3. Set the S3 – S6 jumpers to the proper settings for the function to be used
(refer to Table 9-2 PGD(2)-U10 ADP S3 – S6 Jumper Settings on page 9-4).
Figure 9-2 Remove Cover from PGD(2)-U10 ADP
Figure 9-3 Remove Plastic Cover from Cable Hole