NEC Univerge SV9100 - Figure 3-83 Floor Mount Spacing Guide; Figure 3-84 Secure CHS BASE UNIT with Anchor Bolts

Issue 3.0
3-68 Installing the SV9100 Chassis
SECTION 5 FLOOR MOUNTING THE CHASSIS
5.1 Floor Mounting the 19” (CHS2UG-US) Chassis
The CHS2UG-US controlling and expansion chassis can be mounted on the floor
using the CHS BASE UNIT and the CHS2UG JOINT BRACKET KIT.
5.1.1 CHS2UG-US Chassis Installation
1. Use the template shown in Figure 3-83 Floor Mount Spacing Guide
for required spacing before drilling holes for 0.39” (10mm) anchor
bolts (locally procured).
2. Mark and drill the four holes required to install the CHS BASE UNIT.
3. Using anchor bolts, secure the CHS BASE UNIT to the floor. Refer to
Figure 3-84 Secure CHS BASE UNIT with Anchor Bolts for screw
Figure 3-83 Floor Mount Spacing Guide