NEC Univerge SV9100 - Figure 4-33 Install the CR-2032 Battery

Issue 3.0
4-88 Installing the SV9100 Blades
 Two USB 1.0 ports for USB keyboard support, database backup and
software upgrades
 One 15-pin VGA connector for VHA monitor support
6.1.2 Installation
Only one GCD-VM00 can be installed per system.
1. Wear a grounding strap while handling the GCD-VM00 and lay it on a
flat workspace.
2. Mount the CR-2032 battery with the + side up in the BATT slot on the
GCD-VM00 (refer to Figure 4-33 Install the CR-2032 Battery).
3. To Install the SO-DIMM memory on the GCD-VM00 blade, insert the
end with the brass connectors into the CN14 1 slot first.
4. Push the other end down until the lock on both sides locks into place
(refer to Figure 4-34 Install the SO-DIMM Memory on page 4-89).
WARNING
❍ Handle the CF drive carefully. To prevent damage, do not
drop the drive or apply pressure to it.
❍ This unit makes extensive use of CMOS technology and is
very susceptible to static; extreme care must be taken to
avoid static discharge when handling
Figure 4-33 Install the CR-2032 Battery