NEC Univerge SV9100 - Figure 3-53 Wall Mount Positioning for 9.5 Base;Expansion Chassis

Issue 3.0
3-46 Installing the SV9100 Chassis
4.2 Wall Mounting the 9.5” Gateway (CHS2UG GW-US) and Base
(CHS2UG B-US) Chassis
When wall mounting the chassis, ensure the wall can support the weight of the
chassis and (25 lbs per system chassis ---- including blades, cords, power supply,
etc.). The chassis is secured to the wall with a wall mount bracket.
Optional wall mounting procedures exist for the 9.5” chassis. Option 1: the
mounting bracket is secured to the wall and the chassis is attached to the bracket.
Option 2 attaches the bracket to the 9.5” chassis and then, using the key-holes as
a guide, the assembled unit slides over screws secured to the wall using the
template shown in
 To wall mount the Base and Expansion chassis as a combined unit, refer to
4.2.1.1 Wall Mounting the 9.5” Base (CHS2UG B-US) and Expansion
(CHS2UG E) Chassis on page 3-54.
 To wall mount the CHS2UG B-US with the external battery installed, refer to
4.2.2.2 Wall Mounting the CHS2UG B-US with the CHS2UG B Small Batt
Box on page 3-63.
4.2.1 Option 1 – Wall Mounting the 9.5 inch Base
(CHS2UG B-US)
Chassis
 When mounted, clearance between the wall and the CHS2UG B-US/
CHS2UG E chassis is approximately 1.7 in (43mm) due to height of
the wall mounting bracket.
 The chassis must be mounted horizontally with the slot (front) side on
the right.
 Due to EXIFU cable length, a maximum of 2 (1 CHS2UG B-US and 1
CHS2UG E) chassis can be wall mounted. If additional chassis are to be
mounted, consider using the floor mounting procedure.
Figure 3-53 Wall Mount Positioning for 9.5” Base/Expansion Chassis