Issue 3.0
SV9100 System Hardware Manual 3-115
4. Remove chassis access panel from rear of chassis.
5. Remove cabling from retention clips.
6. Remove two screws securing fan to access cover. Keep screws for
use when installing replacement fan [refer to Figure 3-153 Chassis
Access Panel Removed (19” Chassis)].
10.1.2 Install Cooling Fan
1. Align replacement fan with holes and secure with two screws [refer to
Figure 3-153 Chassis Access Panel Removed (19” Chassis)].
2. Install cabling into retention clips [refer to Figure 3-153 Chassis
Access Panel Removed (19” Chassis) on page 3-115].
3. Insert access panel hinges into slots on rear of chassis.
4. Plug fan power cable into three prong plug [refer to Figure 3-152
Opening Chassis Access Panel (19” Chassis) on page 3-114].
5. Reinstall access cover and secure with retaining screw (refer to
Figure 3-151 19” Chassis Access Panel on page 3-114).
Figure 3-153 Chassis Access Panel Removed (19” Chassis)
To Next Page
Loading...
