Issue 3.0
SV9100 System Hardware Manual 5-91
9. Secure the DCL-60-1/DCZ-60-2 CONSOLE to the bracket
with the two screws provided.
10. Open the small door covering the side option connectors by
pulling the cover latch toward you (refer to Figure 5-100
Serial Cable Installed, ITL, DT700 only).
11. Connect the cable from the DCL-60-1/DCZ-60-2 CONSOLE
to the Side Option Connector on the multiline terminal and
close the cover (DT700/DT800 only).
12. Set the tilt leg on the multiline terminal to the desired height.
Figure 5-99 Securing the DCL-60-1/DCZ-60-2 CONSOLE with
Screws
Figure 5-100 Serial Cable Installed
To Next Page
Loading...
