NEC Univerge SV9100 - Table 4-2 Adding Daughter Board to Chassis Example

Issue 3.0
SV9100 System Hardware Manual 4-7
The system automatically recognizes each blade installed in the system. If a
blade was installed previously in a slot and another type of blade is to be
installed in that same slot, the blade must first be removed from the chassis
and then the slot definition removed using Program 90-05 or deleted
through WebPro Blade Configuration prior to installing the new blade.
This same condition applies to extensions and other devices connected to
the system. For example, if a port was used previously for a telephone and
a DSS Console is to be installed in that same port, the telephone must be
undefined in Program 10-03 before the console is connected.
2.2.3 Order of Installing Trunk Blades
2.2.3.1 Installing GCD-4COTB, GCD-4DIOPA, GCD-4ODTA or
GCD-2BRIA Blades
The order in which trunk blades are physically inserted
determines the numbering plan.
Table 4-2 Adding Daughter Board to Chassis Example
Blade
Slot #
Blade
Extension
Numbers
Blade
Slot #
Blade
Extension
Numbers
1 GCD-16DLCA 101~116
1 GCD-16DLCA 101~116
2 GCD-8DLCA
(no daughter
board)
117~124
2
——
3 GCD-16DLCA 125~140 3 GCD-16DLCA 125~140
—— —
4 GCD-8DLCA
(with daughter
board)
141~156
CAUTION
To avoid unexpected extension/trunk numbering if
the VoIP or Voice Mail daughter board registers
with the system first, install these boards after
the
other extension and trunk blades are installed.