Issue 3.0
8-2 Installing SV9100 Conference Solutions
2. Connect the base unit to the Ethernet jack using the Ethernet cable.
3. Connect the power cord to the base unit and plug it directly into an electrical
outlet.
4. To connect additional units, connect the 12 foot Connection cable to the Link
Out jack on the first phone and to the Link In jack on the second phone.
Figure 8-1 NEC SIP Conference Installation
Up to three additional SIP Conference Max phones for a total of
four may be connected.
Figure 8-2 Install Additional NEC SIP Conference Units
To Next Page
Loading...
