NEC Univerge SV9100 - Figure 3-60 Install Lower Bracket (9.5 Chassis); Figure 3-61 Washer Location (9.5 Chassis)

Issue 3.0
SV9100 System Hardware Manual 3-51
10. Remove the tape preventing the pin washers from falling off the
bottom of the wall mounting bracket. Align the pins shown in step 4
above, with the hinges on the upper and lower brackets mounted on
the 9.5 inch Base (CHS2UG B-US) chassis.
11. Ensure the 2 washers are installed on the lower pin on the wall
mounted bracket.
Figure 3-60 Install Lower Bracket (9.5” Chassis)
Figure 3-61 Washer Location (9.5” Chassis)