NEC Univerge SV9100 - Apply Power to the 19 Chassis; Figure 3-25 Install 19 AC Power Cords (Multiple-Chassis); Install AC Power Cords on Multiple 19 Chassis (Optional); Install Additional Blades 19 Chassis

Issue 3.0
SV9100 System Hardware Manual 3-21
3.3.6 Install AC Power Cords on Multiple 19” Chassis (Optional)
To install the AC power cords, locate the supplied AC power cords and
attach to the AC Inlets located on the back of the Controlling and Expansion
Chassis.
3.3.7 Install Additional Blades 19” Chassis
Refer to Chapter 4, 2.1 Installation and Safety Precautions on page 4-4.
3.3.8 Apply Power to the 19” Chassis
Refer to Chapter 4, 2.6 Powering Up the SV9100 System on page 4-9.
Figure 3-25 Install 19” AC Power Cords (Multiple-Chassis)
AC Power
Cords to
AC Inlets