NEC Univerge SV9100 - Figure 5-46 Attach Tilt Legs to DT Series Terminal

Issue 3.0
5-54 Installing DT Series Digital and IP Multiline Terminals
4.6.2 Install Tilt Legs
1. Place the telephone on a flat surface (button side down).
2. Lay the adjustable Tilt legs on top of the telephone. Refer to Figure
5-46 Attach Tilt Legs to DT Series Terminal.
3. Push the Tilt Legs upward until they snap into place.
4. Lift both ends of Tilt Legs until they come together (refer to Figure
5-47 Connecting the Tilt Legs on page 5-55).
Figure 5-46 Attach Tilt Legs to DT Series Terminal