Issue 3.0
SV9100 System Hardware Manual 6-39
5. Insert the lower claws of the Bottom Unit (see Figure 6-51 Installing
the BHA-L UNIT) into precut holes on the multiline terminal.
6. Align connector on inside of BHA-L UNIT and push down until unit
snaps into place.
7. Set tilt legs to desired position.
8. Place the numbered keypad up.
9. Connect the Line cord and the AC adapter.
Figure 6-50 Removing the Connector Cover
Figure 6-51 Installing the BHA-L UNIT
To Next Page
Loading...
