NEC Univerge SV9100 - Figure 9-153 IVR Server Chassis - Rear View; Figure 9-154 IVR Server Chassis - Input;Output Ports; Table 9-7 External Server - Available Ports

Issue 3.0
9-160 Installing SV9100 Optional Equipment
15.1.2 Rear View
This section provides a listing of the Input/Output ports available on the IVR
Server. Refer to Figure 9-154 IVR Server Chassis – Input/Output Ports and
Table 9-7 External Server – Available Ports on page 9-161 for a listing of
ports found on the back of the chassis.
Indicates channel activity for all hard drives.
Indicates power is being supplied to the systems
power supply units.
This LED should normally
be illuminated when the
system is operational.
The reset button, which is used to reboot the system.
The main power button, which is used to apply or turn
off the system power. Turning off system power with
this button removes the main power but keeps the
standby power supplied to the system.
If you need to service the
system you should unplug
the AC power cord after
shutting down the server.
Table 9-6 External Server – LED Indications (Continued)
LED
Indication
Condition Comments
Figure 9-153 IVR Server Chassis – Rear View