NEC Univerge SV9100 - Figure 3-117 Floor Mount Spacing Guide

Issue 3.0
SV9100 System Hardware Manual 3-93
8.2.1 Floor Mounting the CHSG LARGE BATT BOX
1. Use the template shown in Figure 3-117 Floor Mount Spacing Guide
for required spacing before drilling holes for 0.39” (10mm) anchor
bolts (locally procured).
2. Mark and drill the four holes required to install the CHS BASE UNIT.
WARNING
❍ Because of injury from falling equipment, wall mounting
the CHSG LARGE BATT BOX is not recommended.
❍ Mounting the CHSG LARGE BATT BOX directly on the
floor is not recommended.
TIP
❍ The CHS BASE UNIT raises the height of the CHSG
LARGE BATT BOX 120mm (4.72”).
❍ When the CHSG LARGE BATT BOX and CHS2UG-US
are connected for long term use, the CHS2UG JOINT
BRACKET KIT is used.
Figure 3-117 Floor Mount Spacing Guide