Issue 3.0
SV9100 System Hardware Manual 9-175
16.5.2 Adjusting the Camera Angle
Adjustment of the camera is made using an angle adjustment lever in the
backside of the Doorphone (camera part).
1. The angle of the camera can be adjusted approximately 15 degrees
to each side (upper, right and left). Adjust the visitor image to a
position than can be easily viewed.
2. When adjusting the camera upward, turn the lever downward. If
moving the camera to the left, the lever turn to the left, likewise, if
moving the camera to the right, turn the lever to the right.
3. For adjusting the camera angle, the lever position should be moved
towards the desired edge. Otherwise the lever may slip off at the time
of installation.
When the Camera angle is being adjusted upward, the Angle
Adjustment Stand can be installed.
Fit the Angle Adjustment Stand no more than six degrees from
the mounting bracket. (Installation of screws is not required.)
Installing the Doorphone unit is a simple operation.
The main body of the Doorphone points upward six degrees.
The Doorphone can adjust to 21 degrees, when using an up
angle adjustment (6 degrees) together with a camera angle
adjustment function (15 degrees) from the main body.
Figure 9-171 Camera Angle Adjustment Lever
To Next Page
Loading...
