NEC Univerge SV9100 - Chassis; Figure 3-46 Wall Mount Spacing Guide (19 Chassis); Wall Mounting the Chassis

Issue 3.0
3-38 Installing the SV9100 Chassis
SECTION 4 WALL MOUNTING THE CHASSIS
4.1 Wall Mounting the 19” (CHS2UG-US) Chassis
When wall mounting the chassis, ensure the wall can support the weight of the
chassis (55 lbs per system chassis – including blades, cords, power supply, etc.).
The chassis is secured to the wall with a wall mount bracket. Ensure that enough
space is available to allow the installation of additional expansion chassis.
4.1.1 CHS2UG-US Chassis Wall Mount Installation
1. Use the template shown in Figure 3-46 Wall Mount Spacing Guide
(19” Chassis) on page 3-39 for required spacing before drilling.
TIP
❍ Plywood should first be installed on the wall where the
chassis will be positioned. This allows secure
anchoring of the screws which support the weight of
the chassis.
❍ Due to chassis weight, NEC recommends only a single
CHS2UG-US chassis per wall mount.