Issue 3.0
SV9100 System Hardware Manual 3-81
6. Turn the 9.5 inch chassis over and place in the location to be installed.
7.
Secure the 9.5” assembly to a flat surface with the four screws supplied.
8. Connect grounding wire to chassis. Refer to Chapter 4 paragraph 3.4
Installing the 9.5” Gateway (CHS2UG GW-US) and Base (CHS2UG B-US)
Chassis on page 3-22 for complete details on grounding the system.
9. Refer to 3.3.5 Install AC Power Cords on 19” Chassis on page 3-20 for
installation of the power cord or, Chapter 6 paragraph 2.1 Installation and
Safety Precautions on page 4-4 for installation of blades.
Figure 3-100 Stand Mount 9.5” Chassis
To prevent possible damage to the 19” chassis due to falling, NEC
recommends screws be installed in the stand mount brackets as soon
as possible.
To Next Page
Loading...
