NEC Univerge SV9100 - Figure 3-26 9.5 Chassis (Front View); Installing the 9.5 Gateway (CHS2 UG GW-US) and Base

Issue 3.0
3-22 Installing the SV9100 Chassis
3.4 Installing the 9.5” Gateway (CHS2UG GW-US) and Base
(CHS2UG B-US) Chassis
The CHS2UG GW-US and the CHS2UG B-US chassis have three universal blade
slots for station, trunk and optional blades.
Before proceeding with installation of chassis, ensure site preparation is
completed. The Gateway (CHS2UG GW-US) chassis can be:
 Wall-mounted – refer to 4.2 Wall Mounting the 9.5” Gateway (CHS2UG GW-US)
and Base (CHS2UG B-US) Chassis on page 3-46.
 Stand-mounted – refer to 6.2 Stand Mounting the 9.5” CHS2UG B Chassis on
page 3-78.
The Base (CHS2UG B-US) chassis can be:
 Wall-mounted – refer to 4.2 Wall Mounting the 9.5” Gateway (CHS2UG GW-US)
and Base (CHS2UG B-US) Chassis on page 3-46.
 Stand-mounted refer to 6.2 Stand Mounting the 9.5” CHS2UG B Chassis on
page 3-78.
From the factory, the SG, ETH and PBXG grounds are located inside the chassis
and are connected to the FG (frame ground) on the back of the chassis.
Figure 3-26 9.5” Chassis (Front View)
3 Universal Slots
(Slot 1 for CPU)
Power Switch
and LED