NEC Univerge SV9100 - Figure 6-10 Plugging the AC Adapter into the AC Wall Outlet; Figure 6-9 Placing the Base Unit on the Posts of the Wall Plate

Issue 3.0
SV9100 System Hardware Manual 6-7
6. Place the base unit on the posts of the wall plate and push down until it is
firmly seated.
7. Plug the AC adapter into a standard 120 Vac wall outlet.
Figure 6-9 Placing the Base Unit on the Posts of the Wall Plate
TIP
Because of variation in wall plates, this method is not
recommended.
Figure 6-10 Plugging the AC Adapter into the AC Wall Outlet
NOTE

Do not use an outlet controlled by a wall switch.