NEC Univerge SV9100 - Chapter 9 Installing SV9100 Optional Equipment; Figure 9-1 PGD(2)-U10 ADP; Table 9-1 PGD(2)-U10 ADP LED Indications

Issue 3.0
9-2 Installing SV9100 Optional Equipment
The PGD(2)-U10 ADP connects to any available digital extension port. The
terminal connections made in the PGD(2)-U10 ADP and the jumper settings
determine what features are used for each circuit.
2.2 LED Indications
Table 9-1 PGD(2)-U10 ADP LED Indications lists the LED indications and
provides a brief description of each.
2.3 Setting up PGD(2)-U10 ADP Connections
This sections provides instructions for setting up the PGD(2)-U10 ADP
connections.
Figure 9-1 PGD(2)-U10 ADP
Channel 2
Status LED
Channel 1
Status LED
Table 9-1 PGD(2)-U10 ADP LED Indications
LED Indication Note
LED 1
Green LED when
CH1 in use.
Flashing green LED indicates DIP Switch setting
and programming for CH1 are conflicting.
LED 2
Green LED when
CH2 in use.
Flashing green LED indicates DIP Switch setting
and programming for CH2 are conflicting.
CAUTION
❍ If the PGD(2)-U10 ADP is to be wall mounted, all the cable
connections should be made first.
❍ For the module to ID correctly after setting the jumpers, set the circuit
type to 0 for the module port in Program 10-03-01 prior to connecting
the line cord to the PGD(2)-U10 ADP.