Issue 3.0
4-108 Installing the SV9100 Blades
3. User relocates the Main board to slot 4.
None of the port numbers change. However, the
programming in Program 10-55 must be changed to
reflect this move
The grouping of the three GSWU units to form a 20 port switch
is restricted to reside in a single system location. The grouping
is not allowed where the GSWU units are placed as part of the
NetLink feature in the Univerge SV9100 system.
6.5.2.5 Unmanaged Switch Functions
In the unmanaged mode, a GSWU unit has the following
functions only:
10 Base-T/100 Base-TX/1000 Base-T) Ethernet ports
(x8)
PoE Class 3 (lowest power class)
6.5.3 LED Indications
Table 4-43 GCD-ETIA LED Indications lists the LEDs and provides a
describes what the LED indicates.
6.5.4 Connectors
Backplane Connector – J1 connection to system CPU board and other
boards in the chassis.
Table 4-43 GCD-ETIA LED Indications
Port State LED Display
1000Mbps Link Green Solid
10/100Mbps Link Yellow Solid
No Link Off
Port Activity LED Blinking
To Next Page
Loading...
